Please help to share the Knowledge >>
To connect the plates to power supply it is necessary to use SSL strips as electric wires. To prepare the strips you need to get one long strip width 12MM or 1/2” length 350MM or 13.6” and cut according the dimensions in the drawings using handsaw. Than drill the holes and bend it by hand to the appropriate shape.
The banding hasn’t need to be 100% accurate. Just bend it to the general shape and fine tune it during the next stages.
After bending wrap the strips using electrical tape to prevent unwanted current inside the water.
Part name |
Quanti ty |
Where to get |
Drawing/picture |
SSL strip Width 1/2” Length 13.6” |
1 |
|
|
Hacksaw |
1 |
|
|
Drill |
1 |
|
|
10 MM or 3/8” drill bit |
1 |
|
|
8 MM or 5/16” drill bit |
1 |
|
|
Electrical tape |
1 |
|