Home. HHO BLOG. HHO Generator. Lean Burning. HHO EFIE . O2 Sensor Spacer. Measure Consumption. Increase fuel economy. Full HOD. Safety Instructions. Site map. About Us. Hydrogen First Aid

Please help to share the Knowledge >>

HHO RSS FEED HHO RSS FEED HHO RSS FEED


The core of the cell is 12 treated wallplates which produce the hydrogen/oxygen gas. They are located parallel to each other and the active surfaces must be treated to maximum the performance of the cell.



First of all the holes of the plate need to be drilled out to 10 MM to fit the 3/8” threaded rod.

Afterwards the active surfaces need to be sanded vertically and horizontally using coarse sandpaper. This is done to increase the working area of the surfaces and to give the bubbles an easy way out.




During the whole process do not leave fingerprints on the wallplates. Fingerprints reduce the effectiveness of electrolysis. Work with rubber gloves.

Next.

Part name

Quanti ty

Where to get

Drawing/picture

Stainless Steel wall plate

12

Amazon


30 - 50 grit, coarse sandpaper

1 pack



Good drill

1

Tool King


10 MM or 3/8” bit

1

Tool King


Back to introduction. SSL WALLPLATE